Documents Similar To CINI Manual. Industrial Insulation Manual. Uploaded by. Haris Prawoto. Standard Specification for Hot Insulation (Piping & Equipment). This SPECIFICATION is based on the CINI Handbook “Insulation for Industries”, English. Version, dated 1st October (also known as the ” edition”). This section is based on the Committee Insulation Netherlands. Industry (CINI) Manual “Insulation for Industries”. DACE fol- lows the CINI standard as much as.
|Published (Last):||12 July 2013|
|PDF File Size:||10.21 Mb|
|ePub File Size:||11.90 Mb|
|Price:||Free* [*Free Regsitration Required]|
White Paper June 24, Manula Well Recommendations This document describes general requirements for stilling wells used for radar tank gauging applications. A look at new methods and materials in boiler construction. Removable hot insulation around flanges, valves, etc. CINI is responsible for the compilation and content of this manual.
Atmospheric site conditions e. If approved by the Principal, deviations shall be shown on the piping drawings. Pleasants Company James M. Before insulation work commences the Insulation Contractor shall observe the weather conditions and shall take temporary precautions if necessary to ensure proper application.
The system of DEPs is expected to be sufficiently flexible to allow individual operating companies to adapt the information set forth in DEPs to their own environment and requirements. Dip tank operations flr flammable. Tentative sizes must be allocated to each structural.
In that case the joints shall be finished in the field. For smaller pipe diameters metal jacketing is not recommended. In particular, for those requirements not specifically covered, the Principal will expect them to follow those induatries and engineering practices which will achieve the same level of integrity as reflected in the DEPs.
All insulation products shall More information.
The jacketing selection has been changed. Common demands for Category 2 and 3 installations This is of particular importance where DEPs may not cover every requirement or diversity of condition at each locality.
The responsibility of the engineer is. The thickness of cold insulation systems shall inulation calculated on the following basis: General product information 3.
CINI – International Standard for Industrial Insulation
Tests shall be carried out in accordance with the applicable test methods. All materials and application methods shall be selected to suit local weather and environmental conditions. The Principal may sometimes undertake all or part of the duties of the Main Contractor.
Typical removable covers for spectacle blind flanges in insulaation and horizontal pipes are shown in Appendices 10 and Insulation material for this duty is normally cellular glass.
The mass of removable parts imsulation be less than 25 kg. Where appropriate they are based on, or reference is made to, international, regional, national and industry standards. The mechanical properties, such as compressive strengths, tensile strengths, shear strength and stress-strain behaviour etc.
As an alternative the following solution may be applied: August 1 Waterproofing Showers and Bathrooms Guide The purpose of this guide is to provide guidance on how a shower area or wet room can be successfully imdustries and tiled with the products available.
Cini manual insulation for industries pdf – Google Docs
The CINI Manual deals knsulation hot, cold and cryogenic insulation systems on pipelines and fittings, equipment and storage tanks. Where multi-layering is necessary, longitudinal and circumferential joints shall all be staggered. The sketches are inter-linked with cross-references to other sketches or chapters.
In general this means that aluminised steel or stainless steel jacketing shall be applied. The responsibility of the engineer is More information.
CINI Manual Industrial Technical Insulation
The mechanical vertical and horizontal loads should be obtained from the pipe support manaul e. All of these questions will be answered. Table of Contents Page: The software shall comply with the information given in CINI and related standards.
The thermal insulation and acoustic insulation systems for piping, tanks and equipment shall be able to cope insulxtion thermal expansion or contraction; therefore the insulation and jacketing shall be designed to allow expansion or contraction.